Infratech · Installation
Infratech Mounting Options + Ceiling Clearances
Infratech heaters install via surface mount (wall / ceiling / pole for C/CD), flush mount, or Motif decorative fascia. Each has different clearance needs — here's what clears code.
By Reed · Updated November 10, 2026
What you need
Step by step
Surface mount — standard install
Hangs less than 9½" from the ceiling. The most common residential install. Wall-to-heater clearance is model-specific — pull the manual for your exact heater BTU rating and surface mount pattern.
Flush mount — 8' ceilings
Fits a standard 8' ceiling using Infratech's flush mount frame. Cleaner aesthetic than surface mount — the heater sits recessed into the ceiling. Requires cutting into the ceiling and framing the cutout to Infratech's spec.
Pole mount — C/CD-Series only
C and CD-Series surface-mount heaters can also pole-mount for freestanding patios without a covered ceiling. Follow the pole-mount kit instructions for correct height + guying.
Motif Collection — decorative fascia
Laser-cut decorative metal fascias that cover the heater element face. Decorative only — doesn't change clearance or mounting; adds a visual finish.
Outdoor + moisture rating
All fixtures are certified IP X4 rated — safe for outdoor use including splash exposure. Full safety listings: UL/cUL (File E 29825), NZ/Australia + CE (Wakefield Laboratories, File NSW 21732).
Common mistakes
- Mounting below 7' ceiling. Standard surface mount puts the heater <9½" from the ceiling. If your ceiling is below 7', the heater hangs too low for safe clearance to seated occupants. Flush mount or a higher ceiling is required.
- Installing inside a non-ventilated enclosed garage without clearance verification. 120V models are rated for enclosed areas but need adequate air space around the fixture. 240V models are typically outdoor/open-structure only. Confirm with the model manual.
Hands-on tips
- Order the correct mount kit at the same time as the heater — the kits are model-specific.
- For flush mount, frame the ceiling cutout BEFORE the drywaller finishes. Retrofitting flush mount means tearing out drywall.
Questions people ask
Can I angle the heater downward?
Infratech's published mounting options are flush, surface, ceiling-hung, and pole — tilted angled mounting isn't addressed on the site. Call Infratech if you need an angled install for a specific coverage pattern.
What does IP X4 mean?
Protection against water splashes from any direction — rated for outdoor patios including rain-exposed areas. Not rated for direct submersion or high-pressure water jets.
Was this guide helpful?
Shopping for Infratech?
See Infratech products